GRINDER HOLDER

JOHN NIOLON

GRINDERS EVERYWHERE !!   PILED UP ON WELDING TABLE... CORDS ALL TANGLED !!   EVERYTIME YOU PULL ONE OUT OF THE PILE, YOU KNOCK THREE THINGS ON THE FLOOR. 

FIX IT !!!  

 

Looked all over the internet... welding sites, pinterest, etc..  was looking for a vertical solution to hang my grinders on the center post in the shop...but after thinking about it, I sometimes roll the table outside for more room and to cut down the sparks in the shop, so horizontal it was....  saw lots of horizontal racks...  I opted for easy. 

My welding bench is about 36x30 and on wheels so I can use it to fab inside or outside or move it over to the welder to weld.  I added a piece of 1-1/2" angle iron to one long side and it was perfect for holding 6 grinders...  two cutting, two grinding, one with flap disks and one wire wheel.

angle.jpg (22413 bytes)

Now... I just have to make myself use it...   the two shelves are usually piled with cut pieces, grinders, hammers, etc... cleaned them off and it's amazing how much easier it rolls !!!

So, here's my easy solution for grinder storage

Img_1170.jpg (309663 bytes)